https://www.youtube.com/watch?v=fYw5bYZWl_QDet e nok sikkert ett fasitsvar på nettet en plass, men legger til både en youtube link med litt forklaring.. og en link til en liten forumsnutt der de snakker om preload på nye og brukte lager..
https://www.stevesnovasite.com/forums/s ... hp?t=95804Og ett klipp av preload verktøyet de bruker...fikk ikkje med meg kor masse preload det var her da...
https://www.youtube.com/watch?v=lD8QNQATrNsEllers ett utdrag fra denne sia..
https://sethirdgen.org/10bolt2.htm"Turn the nut until the pinion won't rock back and forth inside the housing. You want to eliminate all play. Now, turn the nut some more, but go very slow, and in small increments. Once all the play is gone, you will start to crush the crush sleeve. Once you crush it, you cannot "uncrush" it, so if you over tighten, you will have to throw the sleeve out, get a new one, and start over. You want between 15-30"/lbs for new bearings, 9-15"/lbs on used bearings."